With spring right around the corner, you need to make sure you are well-equipped to recharge your sprinkler system the right way. If you want to correctly maintain your lawn, you need to make sure you water it adequately. The best way to do this for any lawn is to have an automatic sprinkler system, especially for any lawns that are maintained at a moderate to high level. Automatic sprinkler systems are perfect because those deliver precise amounts of water to all the areas of your lawn. If you have wanted to start up an irrigation system of your own, we explain below how to do so.

Starting an Irrigation System

First things first: if you are planning to start your own irrigation system, you need to know when you can start. You are able to recharge your irrigation system whenever the winter frost leaves the ground. It also is possible to start an irrigation system at any time, though, as long as you are able to shovel with ease down 12 inches, or one foot.

Tips to Start an Irrigation System

One thing you should keep in mind before starting your own irrigation system is that these are unique, yet usually are installed the same way. It also is likely you will be installing your irrigation system in the beginning of the spring.

Pressurizing the System

The first thing you want to do for your irrigation system is to check all of the valve boxes and make sure there are no rodents or debris in those. The next tip is to make sure you re-attach any fittings that you may have removed in the fall and make sure those are secure. After you have fully inspected that the valve boxes and fittings are secure, you want to make sure all of the valves and drains are open, and that you have a water source connected. Once you know the water source is connected, you should start the water source valve and fill up the irrigation system. If and when the water begins to come out of the drain, this is when you need to close the drain valve. The last thing you need to do before you begin to pressurize the system is to close any other valves, including sprinklers, to the outside.

Post-Pressurized System

The real inspections and tests begin for your irrigation system once it is pressurized. The next step you have to take is to run through the stations one by one. You should let each station operate for about two minutes during this process. There are a few things you need to check at each station. You should inspect each station for proper coverage, any leaks, clogged nozzles and anything else you deem out of the ordinary. After you inspect each station, your next move would be to make any adjustments or repairs as necessary from what you found. The last thing you need to do is to review all the sprinkler times on the controller. Then you are good to go.

Irrigation System Installation in Florida

When using your irrigation system you have to make sure you do a full inspection and make any necessary repairs. You also need to know that an irrigation system is a supplement to natural rainfall and you should not overwater your lawn. If you don’t want to install and maintain your irrigation system, have a professional do it for you. In Boca Raton, Florida, there is no one better than Florida Lawn Enforcement. Not only can we install and maintain your irrigation system for you, we also offer a multitude of other services, such as lawn maintenance and landscape design. To learn more about us and what we offer, contact us today.